Tidal Wave Pump Protector Pro Discontinued
Pump Protector Pro
- Model: TWPP14
- For Use With: Direct Drive Pumps
- Input Voltage: 120 VAC
- Max Amps: 14
- Warranty: 1 Year
The easiest way to damage a pump is to run it while it is not fully submersed in water.
Water Levels can be difficult to monitor, especially when the pump is hidden away inside a pump vault or skimmer box, where filtration can restrict water flow to a level that can cause the pump to run dry.
This Tidal Wave Pump Protector, which will automatically shut off a pump before it can be damaged.
Unlike water level sensors, which can cycle on and off repeatedly, leading to pump failure, the TidalWave Pump Protector electronically monitors subtle line power changes that are created by the pump during adverse load conditions.
When the current change exceeds a preset internal threshold, power to the pump is cut off until physically reset.
There is no cycling on and off like with float sensors that reset themselves.
The TidalWave Pump Protector installs easily and instantly calibrates to any pump.
PondMeister Note: Currently will not work with Mag-Drive or Asynchronous Pumps
No Cycling On and Off!
Features
- Calibration/Reset Button
- Warning Buzzer
- Power Cut-Off on Fault
- Works with Existing GFI
- One Year Manufacturer Warranty
Pump Protector Features:
- Simple Installation
- 120 Volt, 14 Amp
- Calibration/ Reset Button
- Warning Buzzer
- Power Cut-Off on Fault
- Works with existing GFI
- Box Dimensions: 5" long x 3.5" wide x 2 1/8" deep
- Cord to power supply: 16" long
- 1-Year Warranty
- Manufacturer Model Number: TWPP14
Protects Against:
- Operating Dry
- Current Spikes
- Current Drops
- Thermal Cycling
- Low Water Flow